as a matter of fact the wheels have stopped
What's good is bad, what's bad is good
you'll find out when you reach the top
You're on the bottom."--Bob Dylan, Idiot Wind
I've been dragging my USB cable and digital camera baggage around all day and failed to post the other pictures and make further comments on the crazy weekend I had. I guess the "after the firing" recovery has taken more time than I thought it might. One shocking realization is that I'm not in my twenties anymore, and an all-nighter has serious implications on one's memory and alertness. The next firing will be different, I swear. [Or my sweet wife, may cease to be sweet to me]
Here is a series of pictures showing how my plates are wadded and fired. This technique was developed by my buddy Will way back when.
Then glue is dropped on all of the wads, then sea shells from Pawley's Island are placed on the wads to make a nice flashing mark where the wad would have left just a dry white dot. The shells resist the salt and keep the plates from sticking, too.
Then the plates are carefully stacked. Just as with the kiln shelves where the posting has to be supported one above the other, the wadding has to be in-line.
Here is the actual stack placed in the kiln. On top of the stack are some cups that also have shells glued to the wadding.
Speaking of posts, aka. kiln furniture. I wad all of the posts so they will stack without wobbling. Also the soft wadding conforms nicely with crooked, warped shelves! Since I use a lot of these, the wadding process gets expedited by rolling a coil of wadding and the running the wadding along each corn and pinching off a little bit rather quickly. There's no need nor time for carefully rolling wads. These wads are glued on as well so that they won't fall off as I stack them into the kiln.
My neighbor Tom Dancer brought over by a little box of glass from his days as a glassblower. I sprinkled some of the blue granulated stuff on these plates as an experiment. I also took some plate glass on the upper edges, hoping it will run down into the center a little bit.
Here's John Simmons, one of the heroes of the firing, coaxing the pyrometer into the 2000's. Not only did John bring a trailer load of kiln dried 3% moisture oak and poplar from Johnson City. He helped cut and stack it as well. John has a few pots in the kiln, and I hope he'll be rewarded for his giant efforts.
Here's John Geci, a neighbor and glassblower getting it hot at the end of the firing.
Here's Courtney Martin, Geci's newlywed, and I kicking some cone nine azz [as gary would say]. We're also sporting some Ayumi Horie His/Hers T's. Git your magic firing shirt here.