Even the bluebirds wanted in on some pottery fun!
But seriously, I have been curbing my enthusiasm for bloggering every little thing I do and have found it very productive!
Who would've known?
After a visit with Turner last week and some close examination of some alkaline glazed pots Catawbaware, I had the thought that some of these handles must have been thrown. It's quite possible that they were pulled, but I had a hunch about some of these. After some brief experience over the past few years of my fascination with this style handle, I thought there's no better way except to do.
here's the cylinder that I will cut the handle from.
I carefully scored with a needle tool. If you go too fast you may lose control of the soft clay and bang up the handle.
The cut handle layed out on the table to measure equal length for each handle.
A trial attachment.
The handle with a coil added to the upper part of the attachment and smoothed in.
Not bad to my eyes. But we'll see where this goes. The only drawback to this kind of handle is that it makes it harder (but not impossible) to balance a piece of glass on the handle to get a glass run in the glaze. But I like the lines and the thinner cross section of the handles. I think they will be easier to hold.
Back to it and then a trip to Asheville for a visit to Kyle's and then Clay Club at Odyssey!